Cart total must meet or exceed $49. You must choose Economy Shipping during checkout. Excludes Special Order, Oversized Items, Hobie and Wilderness Systems products
In Stock
Ships today if ordered within the next
170-06001/1/20185/28/21087/4/20189/3/201811/22/201812/25/2018
Trim Loc Hatch Seal is a flexible PVC trim with a sponge rubber tube attached to provide a secure seal around hatch and other openings. Used by many kayak manufactures on kayaks such as the Ocean Kayak Drifter and Prowler series as well as the Hobie brand kayaks, Trim Loc Hatch Seal is sold by the foot and comes in two versions, top glued and side glued.
Sold by the foot
Used in conjunction with firm plastic hatch covers to create a seal
Not compatible with rubber 'Tupperware' type hatch covers
Available in top glued or side glued
Used by many kayak manufactures on kayaks such as the Ocean Kayak Drifter and Prowler series as well as the Hobie brand kayaks
California's Proposition 65 entitles California consumers to special warnings for products that contain chemicals
known to the state of California to cause cancer and birth defects or other reproductive harm if those products
expose consumers to such chemicals above certain threshold levels. We care about our customers' safety and hope that
the information below helps with your buying decisions.
We are providing the following warning for products linked to this page:
WARNING: This product may contain chemicals known to the State of California to cause cancer and
birth defects or other reproductive harm.
For more information regarding Proposition 65, please visit the California State's website regarding Proposition 65
Here.
Just what I needed to repair the hatch seal on an Ocean Kayak
Prowler 13 - I think I got the side glued. Took just a few minutes to
install and cut to fit. Perfect replacement.
I used this to seal the front hatches on my PA and outback. Added a
couple of three quarter inch straps with clips to replace the elastic and
they're sealed tight.
Bought this to seal the front hatch of my Hobie PA 14. I used the
origianl rubber gasket for the hatch adn glued it to the bottom lip of
the hatch bucket and bought this to put on the top lip of the bucket.
No leaks!!! Easy to install. Only need 8 feet for the bucket.
not large enough for the front hatch of a hobie pro angler can be used
for the center tackle hatch seal on a older model . made better than
stock not glued together
Hobie Revolutions: I wasn't
paying attention when I
ordered the Hatch Seal on my
older Revo and got the Side
Glued seal which seems to
work great and doesn't get
hooked when shoving stuff
in/out of hatch. Time for the
second Hobie hatch seal
replacement and didn't pay
attention again. I ordered the
Top Molded seal which is more
like the original Hobie seal but
it is molded together which
should be more durable than
Hobie's glued seal. Time will
tell.
The same sized trim lock hatch seal proved difficult to source in Australia. Austin Kayak were prompt with quotes, and were able to dispatch it so that it arrived in Australia (half way around the World from Texas)in about a week. The seal is easy to cut to size, and easy to fit to the canoe, and I now again have a watertight hatch.
to reset image
