The Hobie Rudder Mount Pin is the replacement rudder pin for the Hobie Mirage kayaks. Pin attaches the up/down Mirage rudder mount to the kayak hull and operates smoothly without the need for lubrication. Two sizes fit the Sport, Outback, Tandem, and Classic. Fits models produced prior to 2007. Does not work with the Twist and Stow rudders.
Rudder mount pin attaches the rudder mount to the kayak hull
Pin assures a smooth operation without the need for lubrication
California's Proposition 65 entitles California consumers to special warnings for products that contain chemicals
known to the state of California to cause cancer and birth defects or other reproductive harm if those products
expose consumers to such chemicals above certain threshold levels. We care about our customers' safety and hope that
the information below helps with your buying decisions.
We are providing the following warning for products linked to this page:
WARNING: This product may contain chemicals known to the State of California to cause cancer and
birth defects or other reproductive harm.
For more information regarding Proposition 65, please visit the California State's website regarding Proposition 65
Here.
I had to sand the pin down for it
to fit through the (also new)
metal rudder mount. Other than
that it seems fine. ACK checked
their stock and said their pins
fit through their rudder mounts
fine as is. The retaining wire
ring at each end of the pin is a
real pain to remove and replace.
A tiny cotter pin would be better,
but it's a minor point.
to reset image
