Found a better price somewhere else? Use our Price Match tool!
Fill out the form below. Please be sure to include the URL where you found the lower priced item as well as any other information in the notes.
When finished filling out the form, click "Continue". You will be returned to the product page with the price of the item matched.
Checkout as you normally would. Once your order is placed our Customer Relations team will review your order and contact you if necessary.
The Fine Print:
We reserve the right to validate all price matches. Total price matched is the absolute total including shipping. Clearance product is excluded.
No promotions can be combined with any price matched item. This offer/guarantee may stop at any time without notice.
Write a review for Harmony SlideTrax Univ Mounting Plate with Rod Holder
*Please Note: Both colors and patterns are for general reference only. Colors may vary from computer to computer.
It works. What else can you say. Get a rod holder
extender and you got a perfect set up for catching
that BIG ONE !!! Time to FISH !!!
Performed as advertised. The allen screws could be replaced with a knob or wing type screw to eliminate the need for at tool on the water. Rather than carry a whole folding allen set I cut one off and cast in in a piece of 1/2 pvc pipe with west systemd resin and put a lanyard on it. Still more of a pain than knobs but haven't found any yet.
This rod holder is the tits. The only reason I
didn't give it a full five rating is because I wish
the screws used to keep it in the track had a knob
that could be tightened and loosened by hand rather
than a screwdriver...for on-the-water adjustments.
Slidetrax are the best - I have rigged everything off my boat using them, including rigging the rear cargo deck as a cockpit for my 10-y-0 daughter, foot-pegs and all. The rod holder base is plenty low-profile to not be obtrusive when you're not using the rod holder. Changing the position of the base on the rail, though, takes a screwdriver, while all other slidetrax fittings take an allen wrench. I would rather see socket-heat cap screws here instead of the phillips-head.
Excellent piece. I was able to attached my Fish Buddy fish finder to it. I drilled some holes in it to make it closer to my yak, and it is very stable with the fish finder on it. I'm giving it 4 stars only because I thought it was a little pricey.