In-stock: Ships Monday if ordered today! 
The Lowrance Kayak Scupper Transducer Mount is a transducer mounting systems for sit-on-top fishing kayaks that have scupper holes. The Kayak Transducer Scupper Mount is perfect for all Lowrance HDS Elite Mark and X-Series Lowrance Skimmer transducers, both 83/200 kHz and 455/800 kHz DownScan Imaging (DSI) models alike, as well as earlier 1-inch 200 kHz transducers. The Scupper Transducer Mount is easy to install in most any scupper opening with few tools and without messy adhesives. Best of all the Lowrance Scupper Mount positions the Skimmer transducer so it's totally submerged in the water that you're fishing. This guarantees maximum sonar signal return sensitivity, producing the absolute clearest underwater returns of structure and fish possible. Mounting system only, transducers sold separately. | ||||||||||||
|
||||||||||||
| ||||||||||||
|
| Reviewer: | Andy B | Rating: | 4 | Date: | 05/07/2013 |
| Review: | I really wanted a permanent mount for my Humminbird DI transducer in my Hobie Outback. The kit was simple and served the purpose (except I had to trim the knurled knob on my transducer to fit in the Lowrance mounting bracket). I also had to trim the hard disk that keeps the transducer from pulling into the scupper hole too far. The scupper hole was not a uniformly flat surface. My trandsducer would have cleared the ground by about 1/4"-1/2", but I chose not to use the kit because the boot covering the wire attachment point on my transducer seemed to be "open." I was afraid the transducer would have allowed saltwater in and damaged the wires in time. So the transducer went back into the hull. Otherwise I would have enjoyed trying this mount. In this day and age, I cannot believe that manufacturers have not updated their hull molds to add a pocket for the transducer! Hobie...ARE YOU LISTENING!? | ||||
| Reviewer: | Dj | Rating: | 5 | Date: | 02/24/2013 |
| Review: | very easy to install on kayak and tucks the transducer up nicely under the kayak. only had to modify 2 pieces for my needs and that took about 2 minutes. highly recommended! | ||||
| Reviewer: | As Expected | Rating: | 5 | Date: | 01/28/2013 |
| Review: | It does what it says it does... | ||||
| Reviewer: | mark | Rating: | 2 | Date: | 12/27/2012 |
| Review: | I used this product to mount the transducer on my Ocean Kayak trident 13'. Installs easily and no glue mess. BUT, the transducer does not end up flush with bottom of kayak. There is only about an inch of transducer below the scupper hole, but this is something that will have to watched loading and unloading. If I have a problem with it, will remount in hull. | ||||
** 15% off accessories with kayak purchase is not valid on Hobie products.
